Lucent Technologies 9077 04S, 9077 16S, 9076 manual Getver, Grarp, Grcard, Grfins

Monitoring and Management Tools

SP Switch Router command overview

getver

This command tells you the version of the operating system that is currently running. It can also report which release version will be run the next time the system is booted. In this case, getver is used in conjunction with setver. The setver command specifies which release will be run at the next system boot.

grarp

The grarp command displays the ARP table for a given IP address. If you specify grarp with the IP address of the SP Switch Router Adapter card, it returns a physical address that is the switch node number to which this card connects.

# grarp 192.146.162.67

gt030 (0): 192.146.162.67 at 0:0:0:0:0:2

In this example, 192.146.162.67 is the IP address of the SP Switch Router Adapter card in slot 3 (interface name gt030), and 0:0:0:0:0:2 is the switch node number. Other grarp options edit, add, or remove ARP table entries.

grcard

This command displays slot number, media type, and current operating status of the installed media cards.

super> grcard
0	FDDI_V2	running
1	FDDI_V2	running
2	ETHER_V1	running
3	HSSI_V1	running
5	HSSI_V1	running
6	SONET_V1	running
7	ETHER_V1	running
8	FDDI_V2	running
9	ATM_OC3_V2	running
10	HIPPI_V1	running
11	HSSI_V1	running
12	DEV1_V1	running
13	DEV1_V1	running
14	ATM_OC12_V2	running
15	ATM_OC12_V2	running

grfins

This command installs a release onto the internal flash device. In the process, it installs all the new files and converts the system configuration files as required. Rebooting moves the image to RAM.

As an example, if a release has a new /etc/gratm.conf file, grfins does not write over your current version. Instead, it installs a new version of the /etc/gratm.conf.template file. In this way, you can copy the current configuration information into the new .template file, make any changes, and then save that file as the new /etc/gratm.conf.

SP Switch Router Adapter Guide - 1.4 Update 2 3-3