Lucent Technologies 9077 16S, 9077 04S, 9076 manual Contents of /etc/grdev1.conf

Configuring the SP Switch Router Adapter

Step 4. Run dev1config to create grdev1.conf

Contents of /etc/grdev1.conf

Here is an excerpt from the /etc/grdev1.conf configuration file. It shows only the slot 0 card interface entry.

–SNMP expects 16 interface entries, so do not remove any even if they will be unused.

–Leave the “x” in place in front of the IP address and Net Mask parameters.

#more /etc/grdev1.conf

#####################################################################

#DEV1 Configuration

#####################################################################

#There are several variables that an SP Adapter card needs at

#start up. These are handled by a set of GRINCHES whose descriptors

#are indexed by card number and interface number as follows:

#

#2.21.{CARD+1}.1.{INTERFACE+1}

#This template specifies the start-up values for all potential cards

#in a 16-card GRF router. Initially these are default values

#indicating that the card needs to be configured.

#

#The descriptors are grouped by card and interface so that a

#particular interface can be easily configured.

#####################################################################

#	CARD 0 Interface 0
	#
->	2.21.1.1.1.1	"00"	# Extension Node Identifier
	2.21.1.1.1.2	-1	# Node Name

2.21.1.1.1.3"00:00:00:01:00:00:00:02:00:03" # Switch Token

	2.21.1.1.1.4	1	# Switch ARP
	2.21.1.1.1.5	0	# Switch Node Number
	2.21.1.1.1.6	x0.0.0.0	# IP Address
	2.21.1.1.1.7	x0.0.0.0	# Net Mask
->	2.21.1.1.1.8	1024	# Max Link Pckt Len.(bytes)
	2.21.1.1.1.9	0	# IP Host Offset
->	2.21.1.1.1.10	1	# Configuration State
	2.21.1.1.1.11	"sp_00"	# System Name
->	2.21.1.1.1.12	2	# Node State
	2.21.1.1.1.13	0	# Switch Chip Link
	2.21.1.1.1.14	31	# Node Delay (cycles)
	2.21.1.1.1.15	1	# Admin Status
	#

The arrows (->) indicate read-only values that will not be changed.

2-32 SP Switch Router Adapter Guide - 1.4 Update 2