Lucent Technologies 9077 16S, 9077 04S, 9076 SP Switch Router requires a specific configuration file

Configuring the SP Switch Router Adapter

Step-by-step media card configuration

4 Run dev1config to create /etc/grdev1.conf.
The SP Switch Router requires a specific configuration file,	/etc/grdev1.conf, for the
SP Switch Router Adapter card to operate. The dev1config	command creates this skeleton

file using configuration information passed to the router in either of two ways:

a. We recommend using the procedures documented in the “Managing Extension Nodes” chapter of the PSSP Administration Guide. to install the parameters. (This is the same configuration information as described in the recommended method of step 2.) These parameters will only be available to dev1config after the SP Switch Router Adapter card is activated on the SP switch.

or:

b. As an alternative, you can log on to the SP Switch Router and use a UNIX editor to enter the parameters in the /etc/grdev1.conf file.

5Reset the SP Switch Router Adapter card to install configuration files.

Details about each step are provided in the next several sections.

SP Switch Router Adapter Guide - 1.4 Update 2 2-17