Lucent Technologies 9077 04S Change profile settings, Specify card-level parameters Card profile

Configuring the SP Switch Router Adapter

Step 3. Change profile settings

Step 3. Change profile settings

Specify card-level parameters – Card profile

Set specific dev1 card configuration parameters at the Card profile. The fields to set are:

–OPTIONAL: specify ICMP throttling settings

–OPTIONAL: change run-time binaries

–OPTIONAL: change dump variables

This is the card profile for the SP Switch Router Adapter card residing in slot 8. Media card type, dev1, is automatically read into the read-only media-typefield. Other values shown are defaults. At the top level, you see config and ICMP throttling fields:

super> read card 8 CARD/8 read super> list card 8 card-num* = 8 media-type = dev1 debug-level = 0

hssi-frame-protocol = Frame-Relay sonet-frame-protocol = PPP ether-verbose = 0

ports = <{ 0{off on 10 3} {single off} {"" "" 1 sonet internal-osc+ load = { 0 < > 1 0 0 }

dump = { 0 < > off off} config = { 0 1 1 4 0 0 }

icmp-throttling = { 10 10 2147483647 10 10 10 }

Specify ICMP throttling

You can specify ICMP throttling changes for this card in these settings. Refer to Chapter 1 in the GRF Configuration and Management manual for an explanation of each field, or do a set <field-name>?for a brief description. Default values are shown:

super> list ic echo-reply = 10 unreachable = 10 redirect = 2147483647 TTL-timeout = 10 param-problem = 10 time-stamp-reply = 10

Change default echo reply and TTL settings with this series of commands:

super> set echo-reply = 4

super> set TTL-timeout = 12

super> write

CARD/8 written

You do not have to do a write until you have finished all changes in the Card profile. However, you get a warning message if you try to exit a profile without saving your changes.

2-24 SP Switch Router Adapter Guide - 1.4 Update 2