Lucent Technologies 9076, 9077 16S, 9077 04S manual Configuration State ibmSPDepConfigState read-only

Configuring the SP Switch Router Adapter

Step 4. Run dev1config to create grdev1.conf

Configuration State ibmSPDepConfigState (read-only)

is an integer that indicates the final configuration state of the SP Switch Router Adapter card.

1 = not configured

2 = firmware load failed

3 = driver load failed

4 = diagnostic failed

5 = microcode load failed

6 = fully configured

System Name ibmSPDepSysName

is a quoted string which is the host name of the control workstation for the system partition to which the SP Switch Router Adapter card is connected. The format could be anything and is determined by the value specified in the SP system configuration.

Node State ibmSPDepNodeState (read-only)

is an integer, either 1 or 2, that indicates whether the SP Switch Router Adapter card is responding. A value of 2, down, indicates the card is not responding. A value of 1, up, indicates the card is up and can be unfenced if it had previously been fenced from the SP Switch network.

Switch Chip Link ibmSPDepSwChipLink

is an integer with a value that corresponds to the send port number for packets from the adjacent switch chip to the SP Switch Router Adapter card. The card uses this value in the wake-up packet it sends to the adjacent switch chip. The SP system administrator can determine this value from the SDR object for the dependent node.

Node Delay ibmSPDepNodeDelay

is an integer that expresses an estimated amount of clock cycles that can elapse before the switch chip loads a synchronization register in the SP Switch Router Adapter card. The card uses this value in the wake-up packet it sends to the adjacent switch chip. The SP system administrator can determine this value from the SDR object for the switch partition that contains the dependent node.

Admin Status ibmSPDepAdminStatus

is an integer, either 1, 2, or 3, that indicates whether the SP Switch Router Adapter card is set to communicate with the Switch Manager protocol. The SP SNMP Manager sets this value to trigger resetting or reconfiguration of the SP Switch Router Adapter card.

1 = the card is ready

2 = the card is not ready and should be reset

3 = the card needs to be reconfigured and made ready

2-34 SP Switch Router Adapter Guide - 1.4 Update 2