Marathon Computer AACC 2000 manual Button or Name Explanation, OP1, OP2, SP2, Rem

Marathon Monitors Inc.

Button or		Name	Explanation
indicator
			When lit, it indicates that the output installed in
	OP1	Output 1	module position 1 is on. This is normally the
			heating output on a temperature controller.
			When lit, it indicates that the output installed in
	OP2	Output 2	module position 2 is on. This is normally the
			cooling output on a temperature controller.
	SP2	Setpoint 2	When lit, this indicates that setpoint 2, (or a
			setpoint 3-16) has been selected.
	REM	Remote setpoint	When lit, this indicates that a remote setpoint
			input has been selected.
			‘REM’ will also flash when communications is
			active.
			When pressed, this toggles between automatic
			and manual mode:
		Auto/Manual	∙ If the controller is in automatic mode the
			AUTO light will be lit.
		button	∙ If the controller is in manual mode, the MAN
			light will be lit.
			The Auto/Manual button can be disabled in
			configuration level.
			∙ Press once to start an automatic Probe care
			cycle
		Run/Hold button	∙ This RUN light indicates when ever a probe
			care function is in progress
		Page button	Press to select a new list of parameters.
		Scroll button	Press to select a new parameter in a list.
		Down button	Press to decrease a value in the lower readout.
		Up button	Press to increase a value in lower readout.
		Figure 2-3 Controller buttons and indicators

AACC 2000 Carbon 25 Nov. 1, 1997