Marathon Monitors Inc.

MANUAL MODE

If the AUTO light is on, press the AUTO/MAN button to select manual mode. The MAN light comes on.

Power on

The Home display

Check that the MAN light is on.

The upper readout shows the measured temperature, or process value. The lower readout shows the % output.

To adjust the output, press or . . (Note: If Output Rate Limit has been enabled, then the lower readout will show the working

output. If or . is pressed, it will change to show and allow adjustment of, the target output.)

Press

once.

Display units

A single press of flashes the display units for 0.5 seconds, after which you are returned to the Home display.

Flashing of the display units may have been

x 2disabled in configuration, in which case a single press will take you straight to the display shown below.

Press

 

twice.

 

Setpoint

To adjust the setpoint value, press or .

Press

.

Pressing from the Output Power display may access further parameters. These may be in this scroll list if the ‘Promote’ feature has been used (see Chapter 3, Edit Level).

When you reach the end of this scroll list, pressing will return you to the Home display.

AACC 2000 Carbon

29

Nov. 1, 1997

Page 29
Image 29
Marathon Computer AACC 2000 manual Manual Mode, Setpoint