METRObility Optical Systems 8124-01-M ConsoleManagement, Web-BasedManagement, SNMPManagement

•ConsoleManagement

Refer to Chapter 4: Console Management

•Web-BasedManagement

Refer to the CenturyStack Network Management Guide

•SNMPManagement

Refer to the CenturyStack Network Management Guide

Slave Hub Role

Slave hubs supply the stack with additional ports (12/24) and an addi- tional expansion module slot. Slave hubs can be positioned above or below the master hub. The 8112-01-S and 8124-01-S can also act as stand alone unmanaged hubs.

Hub ID

The master hub and slave hubs can be positioned anywhere in the stack and each hub’s ID is automatically assigned based on its position (in the stack).

Segmenting Hubs

CenturyStack hubs can isolate one or both segments (10 Mbps and 100 Mbps segments) from the other hubs in a stack. When a segment is isolated it does not repeat to the other segments in the hub or to other segments in the stack.

Connecting Devices

The dual speed CenturyStack can connect to 10Mbps, 100Mbps, or 10/100Mbps devices due to its auto sensing capability. CenturyStack will auto sense the connected port speed and set its port to match the speed of the connected port.

Cables

CenturyStack ports accept Cat 3, 4 and 5 cables with RJ-45 connectors for 10Mbps connections and Cat 5 cables with RJ-45 connectors for 100Mbps connections. The maximum length of cables, between hub and workstations is 100 meters. The maximum length of cables, between hub and hub is 5 meters for 100Mbps connections and 100 meters for

Installation 19