10.For a hub stack with a master present, you must configure the software for the installed bridge module to enable the internal bridge function because the software default setting is disabled. The default software setting will not allow the internal bridge function to enable. The software must be configured using a master hub.
11.Start a Console or
TX Module LED Indicators
The LEDs on each module indicate port activity. All LEDs are green.
• | Link: | On, indicates a link is up. |
• | TX: | On, indicates a transmission in progress. |
• | RX: | On, indicates receiving data. |
•100M: On, indicates the 100 Mbps segment is linked. Off, indicates the 10 Mbps segment is linked when TX or RX LED is also on. (NOTE: if there is no cable connected to the module, the LED is on by default)
• FDX: | On, indicates the port is set to full duplex. |
| Off, indicates the port is set to half duplex. |
•Collision: On, indicates collision occurring.
Link up Transmit Receive
2 | 3 Ports |
Switch Module
LINK 
100M
TX 
FDX
RX 
COL
100Mbps Segment Full Duplex Collision
TX Module LEDs
