4G9 ENGINE (E - W) - Rocker Arms and Camshafts

11A-8-5

1 mm or less

Timing belt side

Chamfered side

Oil holes

REMOVAL SERVICE POINT

AA" LASH ADJUSTER REMOVAL

Caution

DIf the lash adjuster is re-used, clean the lash adjuster. (Refer to 11A-8-10.)

INSTALLATION SERVICE POINTS

"AA ADJUSTING SCREW INSTALLATION

(1)Install provisionally the screw to the rocker arm. Insert it so that the end of the screw is flush with the edge of the rocker arm or projects slightly (1 mm or less).

"BA ROCKER ARM SHAFT INSTALLATION

(1)Place the end with the larger chamfered side toward the timing belt side.

NOTE

The rocker arm shaft for intake valves has eight oil holes.

(2)Install the shaft with the oil holes toward the cylinder head.

"CA ROCKER ARMS AND ROCKER ARM SHAFT

INSTALLATION

(1)Move the rocker arms in the directions shown in the illustration before tightening the rocker arm shaft bolts.

NOTE

Move the rocker arms until they touch the rocker arm shaft mounting bosses on the cylinder head.

"DA ROCKER ARM SPRING INSTALLATION

(1)Insert the rocker arm spring at an angle to the spark plug guide and then install it so that it is at a right angle to the guide.

E Mitsubishi Motors Corporation

Dec. 1998

PWEE9502-E

Revised