4G9 ENGINE (E–W) – Alternator and Ignition System

11A-3-7

 

REMOVAL SERVICE POINT

 

 

 

MD998781

AA"CRANKSHAFT BOLT REMOVAL

 

(1) Use the special tool to hold the flywheel or the drive

 

 

plate, and then loosen the crankshaft mounting bolts.

 

 

 

INSTALLATION SERVICE POINTS

"AACAM POSITION SENSOR SUPPORT

INSTALLATION

(1)Apply a 3 mm bead of form-in-place gasket (FIPG) to the area shown.

Specified sealant:

Mitsubishi Genuine Part No. MD970389 or equivalent.

MD998781

Crankshaft pulley

Crankshaft bolt

Front flange

 

Crankshaft

 

Clean

WasherDegrease

Big chamfered side

"BAFRONT FLANGE / CRANKSHAFT PULLEY /

CRANKSHAFT BOLT INSTALLATION

(1)Use the special tool to hold the flywheel or the drive plate.

(2)Clean and then degrease the front flange contacting surface of the crankshaft pulley.

NOTE

Degreasing is necessary to prevent decrease in the friction between contacting surfaces.

(3)Clean the bolt hole in the crankshaft, the crankshaft contacting surface and washer contacting surface of the crankshaft pulley, and the washer.

(4)Apply an appropriately small amount of oil to the threads and seating surface of the crankshaft bolt.

(5)Tighten the crankshaft bolt to the specified torque of 182

± 4 Nm.

EMitsubishi Motors Corporation

Jun. 2002

PWEE9502-K

Revised