4G9 ENGINE (E - W) - Timing Belt

11A-4-5

(6)Slightly loosen the tensioner pulley fixing bolt which is tightened temporarily to tighten the belt by a force of the tensioner spring.

 

 

 

(7)

Turn the crankshaft clockwise by two turns.

 

 

 

 

 

 

(8)

Check that the timing marks are aligned.

 

MD998716

 

(9)

Tighten the fixing bolt of the tensioner pulley.

 

 

 

 

 

Set hole (A)

Set hole (B)

"EA AUTO-TENSIONER INSTALLATION

(1)If the auto-tensioner rod is fully extended, set it in the retracted position with the following procedure.

1)Hold the auto-tensioner in a vice, being careful not to tilt it.

2)Slowly close the vice to force the rod in to align hole

(A)of the rod with the set hole (B).

3)Insert a 2.0-mm-Allen key in diameter or similar into the set holes.

4)Remove the auto-tensioner from the vice.

(2)Install the auto-tensioner

Leave the align key until installation of the timing belt is completed.

E Mitsubishi Motors Corporation

Nov. 1995

PWEE9502-A

Revised