4G9 ENGINE (E - W) - Rocker Cover and Camshafts (MIVEC) 11A-8a-3

Sealant

Sealant

INSTALLATION SERVICE POINTS

"AASEMI-CIRCULAR PACKING INSTALLATION

(1)Apply the specified sealant to the area shown.

Specified sealant:

3M ATD Part No. 8660 or equivalent.

"BACAMSHAFT HOLDER ASSEMBLY INSTALLATION

(1)Apply the specified sealant to the area shown.

Specified sealant:

3M ATD Part No. 8660 or equivalent

"CACAMSHAFT INSTALLATION

(1)Ensure that the intake-side and exhaust-side camshafts are not reversed. The exhaust-side camshaft is longer and has a slot in its rear end.

(2)Set the No. 1 piston at the top dead center and install the camshafts with their cams for No. 1 cylinder directed upward so that the No. 1 cylinder becomes the top dead center on the compression stroke.

"DACAMSHAFT BEARING CAP / CAMSHAFT

HOLDER INSTALLATION

(1)Confirm the identification mark on each bearing cap to install the cap in the correct position.

Identification mark

L1: Front bearing for exhaust camshaft

R1: Front bearing for intake camshaft

E Mitsubishi Motors Corporation

Nov. 1995

PWEE9502-A

Added