Timing belt side
8 | 6 | 1 | 3 | 9 |
10 | 4 | 2 | 5 | 7 |
(4)According to the tightening sequence, tighten the bolts to the specified torque 74 Nm.
(5)Loosen all bolts fully.
(6)Retighten the loosened bolts to a torque of 20 Nm in the specified tightening sequence.
(7)Make paint marks on the cylinder head bolt heads and cylinder head.
(8)Give a 90_ turn to the cylinder head bolts in the specified tightening sequence.
(9)Give another 90_ turn to the cylinder head bolts and make sure that the paint mark on the head of each cylinder head bolt and that on the cylinder head are on the same straight line.
90_
90_
Pain mark
Oil passage
Caution
1.If the bolt is turned less than 90_, proper fastening performance may not be expected. When tightening the bolt, therefore, be careful to give a sufficient turn to it.
2.If the bolt is overtightened, loosen the bolt completely and then retighten it by repeating the tightening procedure from step (1).
"EA SEALANT APPLICATION TO OIL PRESSURE
SWITCH
(1)Apply sealant to the threads of the switch.
Specified sealant:
3M ATD Part No. 8660 or equivalent
Caution
Use care not to allow the sealant to plug the oil passage.
E Mitsubishi Motors Corporation | Nov. 1995 | Revised |