4G9 ENGINE (E - W) - Fuel and Emission Control System

11A-5-5

Injector connector

AB

Delivery pipe

<SOHC - MPI for other

than PAJERO io> Projection

INSTALLATION SERVICE POINTS

"AAINJECTORS INSTALLATION

(1)Apply a small amount of new engine oil to the O-ring.

Caution

Be sure not to let engine oil get into the delivery pipe.

(2)While turning the injector to the left and right, install it to the delivery pipe.

(3)Check that the injector turns smoothly. If it does not turn smoothly, the O-ring may be trapped. Remove the injector and check the O-ring for damage, and then re-insert it into the delivery pipe and check once again.

(4)Check that the clearance between the injector connector and the delivery pipe is uniform (A = B).

"BAFUEL PRESSURE REGULATOR INSTALLATION

(1)Apply a small amount of new engine oil to the O-ring. Insert the fuel pressure regulator into the delivery pipe being careful not to damage the O-ring.

Caution

Be sure not to let engine oil get into the delivery pipe.

(2)Check that the fuel pressure regulator turns smoothly. If it does not turn smoothly, the O-ring may be trapped. Remove the fuel pressure regulator and check the O-ring for damage, and then re-insert it into the delivery pipe and check once again.

"CAGASKET INSTALLATION

(1) Position the projection as shown in the illustration.

E Mitsubishi Motors Corporation

Dec. 1998

PWEE9502-E

Added