AA" OIL JET REMOVAL
(1) Knock out the oil jets using an appropriate metal rod.
Caution
1.Be careful not to scratch the cylinder wall.
2.Do not reuse the removed oil jets.
INSTALLATION SERVICE POINTS
"AA OIL JET INSTALLATION
(1)Using a 4.5 mm diameter pin punch, drive in the oil jet to the crankshaft journal until it seats to the bottom.
"BA CRANKSHAFT BEARING INSTALLATION
(1)When the bearings are to be replaced, select correct ones and install them in the correct positions according to the identification marks stamped on the crankshaft and the top surface of the cylinder block.
Crankshaft | Cylinder | Crankshaft bearing | |
journal | block bearing |
|
|
| bore |
|
|
|
|
|
|
Identification | Identification | Identification | Identification |
mark | mark | mark (service | colour (Line |
|
| parts) | production parts) |
|
|
|
|
1 | 0 | S1 | Brown |
|
|
|
|
| 1 | S2 | Black |
|
|
|
|
| 2 | S3 | Green |
|
|
|
|
2 | 0 | S2 | Black |
|
|
|
|
| 1 | S3 | Green |
|
|
|
|
| 2 | S4 | Yellow |
|
|
|
|
3 | 0 | S3 | Green |
|
|
|
|
| 1 | S4 | Yellow |
|
|
|
|
| 2 | S5 | Pink* |
|
|
|
|
*: Older bearings may be marked in red.
E Mitsubishi Motors Corporation | Nov. 1995 | A | Revised |
May 2000 |