4G9 ENGINE (E–W)– Crankshaft, Cylinder Block, Flywheel and Drive Plate 11A-12-5

"DAOIL SEAL INSTALLATION

MB990938

MD998776

Plastigauge

"EA SEALANT APPLICATION TO OIL SEAL CA

Specified sealant:

Mitsubishi Genuine Part No. MD equivalent

"FA DRIVE PLATE BOLT/FLYWHEEL BOLT INSTALLATION

(1)Remove all the ramaining sealant from bolts and thread holes of crankshaft.

(2)Apply engine oil to the flange of bolt.

(3)Apply engine oil into the thread holes of crankshaft.

(4)Apply specified sealant to the thread of bolts.

Specified sealant:

3M Nut Locking Part No. 4171 or equivalent

(5)Tighten the bolts to specified torque.

INSPECTION

CRANKSHAFT JOURNAL OIL CLEARANCE (PLASTIGAUGE METHOD)

(1)Remove oil from the crankshaft journal and he crankshaft bearing.

(2)Install the crankshaft.

(3)Cut the Plastigauge to the same length as the width of bearing and place it on the journal in parallel with its axis.

(4)Install the crankshaft bearing cap carefully and tighten the bolts to the specified torque.

(5)Carefully remove the crankshaft bearing cap.

(6)Measure the width of the Plastigauge at its widest part by using a scale printed on the Plastigauge package.

Standard value: 0.02 – 0.04 mm

Limit: 0.1 mm

Plastigauge

E Mitsubishi Motors CorporationMar.2001

PWEE9502-I

Revised