Bracket A | Bracket B |
|
Exhaust manifold
"AAEXHAUST MANIFOLD BRACKET INSTA
<FRONT WHEEL DRIVE>
(1)Install temporarily the exhaust manifold brackets A and B as shown in the illustration.
(2)Check that both brackets are in close contact with the bosses, and then tighten fully the bracket mounting bolts.
Exhaust manifold
Bracket
Intake manifold
Intake manifold stay
<REAR WHEEL DRIVE>
(1)Temporarily install the exhaust manifold bracket as shown in the illustration.
(2)Verify that the bracket is brought into close contact with the boss on the exhaust manifold, then tighten the bolts to the specified torque.
"BAINTAKE MANIFOLD STAY INSTALLAT
<FRONT WHEEL DRIVE>
(1)Check to ensure that the intake manifold stay is in close contact with the intake manifold and the cylider block before tightening the respective mounting bolts to the specified torque.
Cylinder block
<REAR WHEEL DRIVE>
(1)Install the intake manifold stay with its “UP” mark directed toward the intake manifold.
“UP” mark
EMitsubishi Motors CoMarporation.2001 | Revised |