Mitsubishi Electronics WD-62827 Appendix J Troubleshooting, General TV Operation, Symptom Remarks

Appendix J: Troubleshooting

General TV Operation

	Symptom	Remarks
1.	The TV remote control does not work.	• Check that the batteries are installed correctly.
		• Check that the selected switch is set to “TV.”
		• Be no more than 20 feet from the TV when using the remote control.
		• Program the remote control to operate the TV (Appendix D).
2.	The TV takes several seconds to respond.	• It is normal for digital channels to take longer to tune in.
		• Press ENTER after a channel number to avoid delays.
		• Use a 4-digit number for an over-the-air digital channel.
		• Use a 6-digit number for digital cable channels (your cable service must be able
		to recognize 6-digit channel numbers).
3.	Cable provider needs information to start	On the remote control, press TV MENU and then enter the numbers 999
	CableCARD™ service.	to display the Host ID and CableCARD™ ID information.
4.	You cannot access a channel.	• Use number keys instead of CHANNEL up/down.
		• Be sure the channel you want to view is in memory. See page 65.
		• Check that the TV is turned to the correct device or antenna for that channel by
		pressing the DEVICE button.
		• Make sure the V-Chip lock is off.
		• If you cannot tune to a virtual digital channel even though the TV has already
		memorized digital channels, tune to the actual channel number used by the
		broadcaster. The virtual channel will then be automatically added to memory.
5.	On-screen displays appear each time you change	This is part of normal TV operation.
	a function.
6.	You cannot program the TV to turn on	• The TV may be locked.
	automatically (timer function)	• The clock may not be set.
		• A time-delayed recording may have started.
7.	You have forgotten your V-Chip pass code.	See Appendix C, Bypassing the V-Chip Lock.
8.	V-Chip is not working.	• Make sure that V-Chip is On.
		• If V-Chip Hours are currently set to disable the V-Chip lock, the V-Chip will not
		block programming.
9.	The TV will not turn on after being plugged in.	If green light on front panel is blinking, wait for at least one minute for
		the light to turn off, then press Power again.
10.	TV functions do not respond to the remote control	Use the System Reset button.
	or to front panel control and TV will not power off.
11.	TV turned itself off and the light on the front panel	• Momentary power fluctuation caused the TV to turn off to prevent damage. Wait
	started to blink.	for the green light to stop flashing and turn On again.
		• If the TV does not stay turned On, use the System Reset button. If this happens
		frequently, obtain an AC line power conditioner/surge protector.
		• An unusual digital signal may have been received, triggering a protection
		circuit. Wait for the light to stop flashing and turn TV on.
12.	Name options not available for some channels.	Only memorized analog channels can be named.
13.	When a device is selected from the Device	• Make sure the selected device is turned on.
	Selection menu, the screen is blue (no signal	• From the Edit NetCommand® menu select Review setting. Verify that the devices
	source).	are physically connected to the TV inputs as listed. If they are not, either change
		the physical connections on the back panel, or select the Change setting on
		the Edit NetCommand menu to change the TV NetCommand’s settings for the
		connection.
		• Begin play of the VCR.

Appendices 115