NetCommand® Initial Setup, continued Setup Reminder
Review Screen
Figure 5
After you have made your device choices, the Review Screen will display. It is important to review the settings to ensure that they are correct. If necessary, you can use <Back to return to the Device Setup screen to make changes.
Figure 5. Review screen
Note: The Review screen lists the TV input and A/V receiver input used with each device. You must correctly identify the inputs you used when you connected the devices. If you have not connected your devices, write down these inputs as a guide. If you cannot use these inputs, or if you would like to change the name of a device, use the instructions in Edit NetCommand to make necessary changes.
Note: If you select Next> on the Review screen, all selections made are finalized.
On the Review screen, adding or deleting check marks will turn the adjacent devices or inputs On or Off. 1394 device names only appear on the Review screen when the devices are connected to the TV.
Finish Screen
Figure 6
To complete the NetCommand setup, select Finish from the Finish screen.
If you wish to change any of the
If your A/V receiver was not listed, select Edit to add the AVR and then assign all devices to new AVR inputs.
Figure 6. Finish screen
It may still be necessary to memorize the available channels for
Setup Reminder
Figure 7
This screen only appears if you did not set up NetCommand when the TV was first turned on. The Setup Reminder screen displays the next six times you power on the TV if you do not perform setup.
If you want to set up NetCommand and/or the TV Guide On Screen system, select Next and press ENTER. If you do not wish to perform setup, select Cancel and press
ENTER.
Figure 7. Setup Reminder screen
42Chapter 3. NetCommand Setup and Editing
