Appendix H: Diamond Shield Removal and Installation

The Diamond Shield ™ is an optional protective cover for the front of the TV screen. Models WD-62927 and WD-73927 come from the factory with the Diamond Shield installed. For Models WD-62827 and 73827, the Diamond Shield may be purchased separately.

These instructions explain removal and installation of the Diamond Shield™ and the decorative trim that covers gaps around the TV screen when the shield not installed.

You need the following for this procedure: Trim kit (included with the TV) Phillips screwdriver

Small plastic card or plastic putty knife. An expired credit card or similar expendable card works well. Soft cotton gloves

Note: Use care to avoid scratching the TV screen or Diamond Shield. This procedure is best performed by two people.

 

 

 

 

 

 

 

Top Plate

 

 

Remove the Shield

 

 

 

Figure 1. Remove the

1. Using a Phillips screwdriver, remove the screws that

 

 

 

secure the top plate and lift off the plate. Keep the

 

 

 

screws securing the

plate and screws for reuse. See figure 1.

 

 

 

top plate and lift off

 

 

 

 

the plate.

 

 

 

 

 

2. Note the location of the six clips that hold the

Diamond Shield in place. Slide the card along the

 

channel until it meets each clip. See figures 2 and 3.

Diamond Shield

 

See figure 3 detail

 

Slide card in channel to locate clips. The clips are visible at the edge of the Diamond Shield.

Figure 3. Locating the clips

Figure 2. Six clips hold the Diamond Shield on the TV.

Appendices 111

Page 111
Image 111
Mitsubishi Electronics WD-62827 manual Appendix H Diamond Shield Removal and Installation, See detail