Connecting a PC
Overview
1.Connect the Computer to the TV
See the connection diagrams in this chapter to find the method best suited to your needs.
2.Perform NetCommand Setup for the PC
•For
Start NetCommand setup as described in chapter 3 and check mark the PC check box in the Device Setup screen.
•If NetCommand has already been set up: Press TV MENU and select the NetCommand icon. In the Edit NetCommand screen, select Add and follow the
3.Select the PC in the Device Selection menu
1Press DEVICE to open the Device Selection menu.
2.Move the highlight to the PC icon.
3.Press DEVICE again to close the menu.
4.Change the resolution of the PC image
Maximize the resolution while maintaining a suitable aspect ratio for the image. See the explanation later in this chapter.
5.Perform TV video adjustments
Press VIDEO repeatedly until you see the PC video settings displayed on screen. Your choices are:
Auto Position. Press ENTER to automatically center the position of the PC video.
HorizPosition (Horizontal Position). Manually adjust the horizontal position of the PC. This selection overrides the Auto Position selection.
VertPosition (Vertical Position). Manually adjust the vertical position of the PC. This selection overrides the Auto Position selection.
Fine Detail. Manually adjust the picture quality of the PC. This selection overrides the Auto Position selection.
6.Change the TV picture format
Press FORMAT to cycle through the available picture formats. See the chart later in this chapter showing how various PC resolutions are displayed on the TV.
Computer with an HDMI Monitor Output
Figure 1
An
1.Connect an HDMI cable from HDMI 2 on the TV back panel to the PC’s HDMI output. Both video and audio are provided through this single cable.
2.Models
a.Perform the NetCommand PC setup described in step 2 under “Overview” on this page.
b.Select the NetCommand Change option as follows:
(1)Press TV MENU.
(2)Highlight the NetCommand icon and press
ENTER.
(3)Highlight Change and press ENTER.
3.In the Connection for PC screen, change TV Input from PC to
4.Advance to the finish screen to complete the change.
|
|
|
|
| 1$'03)%.* |
|
|
|
|
| |
|
|
| )%.* |
| 7("87(" |
|
|
|
| 47("847(" | |
|
|
|
| 9("9 | |
*3&.*55&3 |
|
|
|
|
|
/FU$PNNBOE¸ |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
'6)' |
|
|
|
|
|
64&8*5) |
|
|
|
|
|
$BCMF$"3% |
| %*(*5"- |
|
|
|
|
|
|
|
| |
|
| "6%*0 | $BCMF$"3%64&8*5)"/5$"3%501 |
|
|
"/5"69 | "/5."*/ | 065165 |
|
| |
|
|
|
|
| *&&& |
|
|
|
|
| */165 |
|
|
|
|
| 065165 |
1$XJUI)%.*0VUQVU
Figure 1. Connecting a Computer with an HDMI Monitor Output
CAUTION: To ensure continued FCC compliance, the user must use a shielded video interface or HDMI cable
with bonded ferrite cores at both ends when using the PC input.
IMPORTANT
•After connecting the PC, activate the PC option in NetCommand. Do this either during initial NetCommand setup (in the Device Setup screen), or at any time afterwards with the NetCommand Add function. See chapter 3.
•See Appendix A for signal compatibility.
92Chapter 7. Using the TV with a PC
