Mitsubishi Electronics WD-62827 manual Appendix a Specifications, TV Specifications, Inputs

Appendix A: Specifications

From time to time, Mitsubishi may offer software updates to expand the features or operation of this TV. When these updates are available they will be announced on our web site, Mitsubishi-tv.com. If you return your owner’s registration card, with your model and serial number, you may receive written notification of available software updates.

TV Specifications
Projection System	DLP, 0.843” chip, 1920 x 1080 pixels with Smooth Picture™
Lamp	150-watt VIP type
Channel Frequency Reception	Over-the-Air: VHF 2–13, UHF 14–69
	Analog Cable: 1–125
	Digital Cable: 1–135
Channel Type	Over the Air:	Analog NTSC, Digital ATSC with sub-channels (all 18 video
		formats)
	Cable:	Analog NTSC (non-scrambled)
		Digital QAM 64 and 256 with sub-channels (non-
		scrambled)
	CableCARD™: Authorized scrambled and non-scrambled digital
		channels

Note for Digital Channels: The channel numbers displayed on screen are determined by the broadcaster or cable company and can vary from the standard frequency number. If there is no channel number information included from the broadcaster or cable company, then the TV will create a channel number based on the frequency number as the

main channel number and the program number as the sub-channel number. When using an authorized CableCARD,
the channel numbers are determined by the cable company.
Inputs
Antenna/Cable input Qty. 2	F connector, 75-ohm
HDMI (digital video/audio), Qty. 2	HDMI standard connector
Signal Type	HDMI EIA-861B standard for digital audio and video.
	Video: 480i, 480p, 720p, 1080i
	Audio: PCM stereo
	HDMI 1: Not intended for use with personal computers.
	HDMI 2: Accepts PC input.
	VGA (640 x 480), 60-Hz
	W-VGA (848 x 480), 60-Hz
	SVGA (800 x 600), 60-Hz
	W-SVGA (1064 x 600), 60-Hz
	XGA (1024 x 768), 60-Hz
	1280 x 720, 60-Hz (EIA standards)
Video/S-Video, Qty. 3 each	Video:	RCA Pin Plug, 1.0 V p-p, 75 ohm
(1 front, 2 rear)	S-Video: Four-Pin DIN Plug
		Y: 1.0 Vp-p 75-ohm
		C: 0.286 Vp-p (burst signal), 75-ohm
Signal Type	NTSC 480i only
Component Video (Y/Pr/Pb), Qty. 3 sets	RCA Pin Plug (EIA-770.3 Standard Levels and Timing)
	Y:	1.0 Vp-p (includes sync), 75-ohm
	Pr:	700 mV p-p, 75-ohm
	Pb:	700 mV p-p, 75-ohm
Signal Type	EIA-770.1 & EIA 770.2 480i, 480p, EIA 770.3 720p and 1080i (video standards)
Audio Inputs: Qty. 8 pairs	RCA Pin Plug 500 mV (full scale), 43-k ohm

98Appendices