Configuration | Section 3 |
|
|
FILTERS Page – All Configuration Options
| Field | Description |
| |
|
|
|
| |
| LAN MAC Filter |
| Sets whether local network clients (specified by MAC address) are | |
| Mode: |
| allowed or denied access to your broadband connection. | |
| (ADVANCED) |
| • Selecting Allow will allow access only by the clients identified | |
|
|
| by the Filtered LAN MAC Addresses below. | |
|
|
| • Selecting Deny will deny access by the clients identified by | |
|
|
| the Filtered LAN MAC Addresses below. |
|
|
|
| • Selecting Disabled will suppress all MAC address filtering, | |
|
|
| and allow all clients access to your broadband connection. | |
|
|
| FACTORY DEFAULT: Deny |
|
| Filtered |
| Sets a list of up to 10 LAN clients (specified by MAC address) from | |
| LAN MAC |
| which communications are filtered as per the LAN MAC Filter Mode. | |
| Addresses: |
| NOTE: A MAC address has a format of: XX:XX:XX:XX:XX:XX. | |
| (ADVANCED) |
| ||
|
| FACTORY DEFAULT: (blank) |
| |
|
|
|
| |
| LAN Usage |
| Sets rules whereby LAN clients (specified by IP address) are not | |
| Filters: |
| allowed access to certain port ranges during specified times. For | |
| (ADVANCED) |
| example, clients might be temporarily blocked from Internet use. | |
|
|
| NOTE: These settings are only used if Operation Mode on the BASIC | |
|
|
| Page is set to Router. |
|
|
|
| You can store up to 20 filtering rules, and selectively enable one or | |
|
|
| more of them when desired, using the Enabled checkbox at the end | |
|
|
| of each row. |
|
|
|
| NOTE: Filtering rules will be applied in the order in which they are listed | |
|
|
| on this page. |
|
|
|
| For each filtering rule, the following 5 items must be entered: | |
|
|
| (1) LAN IP Address Range: |
|
|
|
| These two fields define a range of LAN clients to which the filtering | |
|
|
| rule will apply. To apply a rule to a specific client, enter the same IP | |
|
|
| address in both fields. |
|
|
|
| FACTORY DEFAULT: (blank) |
|
|
|
| (2) Protocol: |
|
|
|
| This field specifies the Internet communication Protocol that will be | |
|
|
| restricted as per the filtering rule. | (continued on next page) |
|
|
|
|
|
WR850 |
