Motorola WR850GP manual LED Description, Led

Section 1 Overview

LED Description

LED	Condition	Color	Status
1 Power	ON	Green	The device is powered on and operating normally.
	ON	Red	The Power LED turns RED as soon as the reset
			button is depressed. If the reset button is held
			down, the LED starts to blink RED and the
			router’s username, password, private LAN IP
			address, private subnet mask address and
			operation mode are restored to factory default
			settings.
			If the Power LED stays RED for longer than 5
			seconds, this indicates that the firmware is
			corrupted and needs to be restored.
	OFF	None	The device is not powered on.
2 Modem	ON/Blinking	Amber	10BaseT link detected / active traffic present.
	ON/Blinking	Green	100BaseT link detected / active traffic present.
	OFF	None	No external Ethernet device has been attached
			and detected. The Ethernet link may be down.
3 Wireless	ON/Blinking	Green	The wireless interface is enabled / active traffic
			present.
			NOTE: The wireless LED does not blink on WR850G
			“Version 1” hardware. You can determine
			your version of hardware by looking at the
			product label on the bottom of the router.
			Within the box that includes the FCC logo, a
			“Version 1” unit will display “MODEL:
			WR850G”, while a “Version 2” unit will display
			“MODEL: WR850Gv2” (see example below).

INPUT VO	+5VDC, 2A
FCC ID: F2N	0G

MO WR850G

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

MODEL WR850G

PART NUMBER: AAAAAA-BBB-CC

S/N: PPPPMMYJJJSSSSSCAABBCCCC

WIRELESS MAC: AB CD EF 01 23 45 WAN MAC: AB CD EF 01 23 45 MADE IN TAIWAN

OFF	None	The wireless interface is not enabled by the
		firmware.
4 LAN (x4) ON/Blinking	Amber	10BaseT link detected / active traffic present.
ON/Blinking	Green	100BaseT link detected / active traffic present.
OFF	None	No external Ethernet device has been attached
		and detected. The Ethernet link may be down.

1-8 WR850