Motorola WR850GP manual LAN IP Address, LAN Port Range, Port Triggers

Section 3 Configuration

Port Forwards:	To forward communications from a single port, enter the same port
(continued)	number in both fields.
	This information must be entered for each port forward.
	FACTORY DEFAULT: (blank)
	(2) LAN IP Address:
	Sets the client on your local network (specified by IP address) to
	which communications will be forwarded.
	This information must be entered for each port forward.
	FACTORY DEFAULT: (blank)
	(3) LAN Port Range:
	These two fields (“Start” and “End”) define a range of LAN ports to
	which communications will be forwarded. To forward to a single
	port, enter the same port number in both fields.
	This information is optional for each port forward.
	FACTORY DEFAULT: (blank)
Port Triggers:	Sets rules for forwarding inbound communications (from your
(ADVANCED)	broadband connection) based on specific outbound communications
	(or “triggers”) from a LAN client.
	Specifically, if a LAN client transmits to the Internet using any of a
	set of outbound destination ports, they will be forwarded Internet
	responses that are received on a corresponding set of inbound
	destination ports.
	You may optionally specify a destination port range for forwards, on
	the LAN side of the WR850, as well.
	This feature can be particularly useful to support real-time games
	which require Internet responses to game activity. These responses
	might otherwise be blocked by the WR850 firewall.
	NOTE: These settings are only used if Operation Mode on the BASIC
	Page is set to Router.
	You can store up to 20 port triggers, and selectively enable one or
	more of them when desired, using the Enabled checkbox at the end
	of each row. If more port triggers are required, especially for a
	single client, you should consider configuring the client as a DMZ.

NOTE: Port triggers will be applied in the order in which they are listed

on this page. (continued on next page)

3-38 WR850