Motorola WR850GP manual Recommended Setting a Pass Phrase of at least 20 characters

Section 3 Configuration

Field	Description
WPA2-PSK:	3) WPA2-PSKand WPA-PSK(above) can be enabled
(continued)	concurrently, to support devices with mixed capabilities.
	4) WPA2-PSKcan be used concurrently with WEP Encryption, if
	needed for backward compatibility. WEP Encryption is
	enabled separately from WPA Encryption (below).
	FACTORY DEFAULT: Disabled
	RECOMMENDED SETTING: Enabled
WPA	Sets the encryption method(s) to be used with WPA, WPA2, WPA-
Encryption:	PSK, or WPA2-PSK authentication.
(RECOMMENDED)	• Selecting TKIP engages Temporal Key Integrity Protocol.
	• Selecting AES engages Advanced Encryption Standard.
	• Selecting TKIP + AES allows the WR850 to support a mix of
	devices using these two encryption methods.
	NOTE: WPA Encryption is greyed out and unchangeable unless WPA,
	WPA2, WPA-PSK, or WPA2-PSK is Enabled.
	FACTORY DEFAULT: TKIP
	RECOMMENDED SETTING: TKIP + AES
WPA Pass	Sets the pass phrase (or Pre-Shared Key) that will be used to
Phrase:	generate encryption keys, with WPA-PSK or WPA2-PSK
(RECOMMENDED)	authentication. The entered pass phrase must be:
	• between 8 and 63 alphanumeric characters, or
	• exactly 64 hexadecimal digits (0-9, A-F).
	A WPA Pass Phrase of at least 20 characters is strongly
	recommended, for stronger security.
	For security reasons, the pass phrase is not immediately readable,
	while it is being entered. After you apply your changes to the
	SECURITY Page (i.e., by clicking the Apply button at the bottom of
	the page), you can use the Show button to the right of this field to
	review the entered value.
	This will allow you to recall your WPA Pass Phrase and enter it into
	the wireless devices with which the WR850 will communicate.
	NOTE: A WPA Pass Phrase cannot be entered unless WPA-PSKor
	WPA2-PSK is Enabled.
	FACTORY DEFAULT: (blank)
	RECOMMENDED SETTING: A Pass Phrase of at least 20 characters

3-60 WR850