Configuration | Section 3 |
|
|
Field | Description |
EDCA AP and | Configuration settings are available to individually adjust EDCA |
Client Parameters: | parameters for WR850 transmissions (EDCA AP parameters) |
(continued) | and for client device transmissions (EDCA Client parameters). |
| You can set, left to right for each Access Category, the following |
| EDCA parameters: |
| • a minimum CW (in slots) |
| • a maximum CW (in slots) |
| • the AISFN (in slots) |
| • a TXOP Limit (b) for 11Mbps 802.11b operation |
| (in microseconds) |
| • a separate TXOP Limit (a/g) for 54Mbps 802.11g |
| operation, since more capacity is available |
| (in microseconds) |
| [this last field references 802.11a as well, per WMM standards, |
| since 802.11a is also a 54Mbps wireless technology] |
| You can selectively enable and disable specific EDCA parameter |
| settings, on an AC by AC basis, by selecting On or Off in the |
| Admin Forced dialog box at the end of each row. |
| FACTORY DEFAULTS: All settings Off |
Options related to: CONFIGURING THE WR850 AS A WIRELESS BRIDGE (to extend an existing wireless network)
Field | Description |
Wireless Bridge | In a typical wireless network configuration, the WR850 serves as |
Operation: | wireless access point for clients. However, using |
(ADVANCED) | Wireless Distribution System (WDS) functionality, the WR850 can |
| be used as a wireless bridge, specifically communicating with |
| other bridges (and/or access points) to create a larger network. |
| (continued on next page) |
|
|
WR850 |
