Multi-Tech Systems DT101/xx, DT102/xx owner manual 108, Fxs

DataTalker Owner’s Manual

Voice/Fax Channel 1 Configuration

1	- Destination Channel		: 1
2	- Digitizing Rate		: 9600
3	- Output Level Atten.		: 12
4	- Input Level Gain		: 03
5	- Silence Suppression		: Off
6	- Local Interface Type		: FXS
7	-	Ground/Loop Start (FXS)	: Loop
8	-	2 or 4 Wire (E&M)	: N/A
9	-	Dialtone/Wink (E&M)	: N/A
10	-	Wink Timer (E&M)	: N/A
11	- Remote Interface Type		: FXS
12	-	Ground/Loop Start (FXS)	: Loop
13	-	2 or 4 Wire (E&M)	: N/A
14	-	Dialtone/Wink (E&M)	: N/A

S- Store All Configurations M - Main Menu

P - Previous Menu

Selection : _

7Verify the voice/fax channel configuration. To change the configuration, enter the appropriate option numbers.

Options 1 through 10 are for the local interface. Options 11 through 14 are for the remote interface. Note that the remote interface options do not actually change the remote interface; they only tell the local DataTalker how the remote interface is configured. Any changes in the remote interface must be done at the remote site. See Chapter 6 for descriptions of the Voice/Fax Channel 1 Configuration menu options.

8When all the options for the voice/fax channel are set, enter S and press ENTER to store all configurations. Then enter M and press ENTER to return to the Main Menu.

9Disconnect the terminal or PC from the command port and place DIP switch position 3 in the up (OPEN) position to change the command/data port over to a data channel.

108