Multi-Tech Systems DT101/xx, DT102/xx owner manual V.35 Shunt Procedure, Step Procedure

DataTalker Owner’s Manual

5.3 V.35 Shunt

Table 5-2. V.35 Shunt Procedure

Step Procedure

1Desktop version: Unplug the power supply from the back of the unit.

Rack version: Remove the unit from the RackTalker rack. Go to step 4.

2Desktop version only: Turn the unit upside down and remove the two cabinet mounting screws from the middle of the cabinet.

DATA/

COMMAND XMT RCV FC COM ORIG

Data / Voice / Fax Concentrator

VOICE /

FXS

FXO

E&M

FAX

XMT

RCV

XSG

RSG

RXT

FCR

RD

TM

V35

EXT

MDM

DSU

TA

FAX 2

COMPOSITE

LINK

28.8

DTR

DBUP

OH

VOICE /

STATUS

FXS

FXO

E&M

FAX

XMT

RCV

XSG

RSG

CD

RCV

XMT

CTS

56

RTS

NS

OOS

2B

FAX 1

101 MDM / TA

Cabinet

Mounting

Screws (2)

Figure 5-11. Cabinet Mounting Screws

3Desktop version only : Turn the cabinet right-side up, tilt the back down slightly, and the base unit will slide out of the cabinet.

4Desktop and rack versions: Place the unit with the LEDs facing you.

5Pry the shunt out of the RS232 socket and insert it into the V.35 socket. Rack version: Go to step 8.

RS-232

Shunt

V.35

Shunt

Figure 5-12. V.35 Shunt Location (Desktop Version)

6Desktop version only: Slide the base back into the cabinet with the LEDs toward the front and the rear grounding tabs pressing against the side of the cabinet.

7Desktop version only: Turn the unit upside down and replace the two cabinet mounting screws.

8Desktop version: Turn the unit right-side up and reconnect the power supply.

Rack version: Slide the unit into the RackTalker card guides and, after ensuring that the DataTalker is fully seated, fasten the retaining screws.

60