DataTalker Owner’s Manual

9Configure the data port to meet the conditions of your installation by selecting option numbers from the menus. Refer to Chapter 6 for a description of the Data Port Configuration menu options.

For example, if you are setting up the data port as a sync data channel, enter number 1 and press ENTER. The Data Port Async/Sync menu appears:

Data Port Async/Sync

1 - Async

2 - Sync

P- Previous Menu

Selection : _

Select option 2 to select the sync mode of operation, and the data port configuration menu reappears.

10When all options for the data port configuration have been set, enter the letter S and press ENTER to store all configurations. Then enter the letter P and press ENTER to return to the configuration menu.

Voice/Fax Channel Configuration

11If the voice/fax channels of both the local and remote DataTalkers are being connected to telephone sets, i.e., both local and remote interfaces are FXS type, then you can skip the Voice/Fax Channel Configuration menu. Proceed to the Composite Link Configuration menu.

If either the local or the remote voice/fax channel is being connected to a PBX, then you must configure the voice/fax channel. Enter 2 and press ENTER for the Voice/Fax Channel Configuration menu.

If two voice/fax channels are installed in the DataTalker, a voice/fax channel configuration menu appears that allows you to configure either channel. Select the voice/fax channel that needs to be configured.

Voice/Fax Channel 1 Configuration

1

-

Destination Channel

: 1

2

-

Digitizing Rate

: 9600

3

-

Output

Level Atten.

: 12

4

-

Input Level Gain

: 03

5

-

Silence Suppression

: Off

6

-

Local Interface Type

: FXS

7

-

Ground/Loop Start (FXS)

: Loop

8

-

2 or

4 Wire (E&M)

: N/A

9

-

Dialtone/Wink (E&M)

: N/A

10 -

Wink

Timer (E&M)

: N/A

11 -

Remote

Interface Type

: FXS

12 -

Ground/Loop Start (FXS)

: Loop

13 -

2 or

4 Wire (E&M)

: N/A

14 -

Dialtone/Wink (E&M)

: N/A

S- Store All Configurations M - Main Menu

P - Previous Menu

Selection : _

50

Page 50
Image 50
Multi-Tech Systems DT101/xx, DT102/xx owner manual Voice/Fax Channel Configuration