Multi-Tech Systems DT101/xx, DT102/xx owner manual Configuration Procedure

DataTalker Owner’s Manual

4.7 Configuration Procedure

Table 4-1. Configuration Procedure

Step Procedure

1Review the configuration considerations for the data port, the voice/fax channel, and the composite link in the previous sections.

2Place DIP switch position 3 in the down (closed) position to enable the command port.

						DATA/COMMAND
DIAL-UP	LEASED	DIGITAL	E&M	FXO	FXS	GND
						RS232C/V.35
MODEM		DSU/TA	VOICE/FAX CHANNEL 1			EXTERNAL COMPOSITE
						POWER
INTERNAL COMPOSITE

DIP Switch

3Desktop version: Connect the DC power supply shipped with the DataTalker to the power connector on the back panel and to the AC outlet.

Rack-mounted version: Insert the DataTalker into a RackTalker rack.

4Connect a terminal or PC running communications software to the DATA/COMMAND connector on the back panel of the DataTalker. Use an appropriate RS232 cable to connect the DATA/COMMAND connector to your PC’s serial port. The terminal or PC serial port may be labeled COM1, COM2, or Serial Port. The DATA/COMMAND connector has a DCE physical interface.

					DATA/COMMAND
DIAL-UP LEASED DIGITAL		E&M	FXO	FXS	GND
					RS232C/V.35
MODEM	DSU/TA	VOICE/FAX CHANNEL 1			EXTERNAL COMPOSITE
INTERNAL COMPOSITE					POWER

DATA/COMMAND

Connector

RS232 Cable

Note: Any cables connected to the computer should be shielded to reduce interference.

5Desktop version: Apply power to the DataTalker by placing the power switch on the back panel in the on (I) position.

Rack-mounted version: Apply power to the RackTalker rack if it is not already on.

					DATA/COMMAND
DIAL-UP LEASED DIGITAL		E&M	FXO	FXS	GND
					RS232C/V.35
MODEM	DSU/TA	VOICE/FAX CHANNEL 1			EXTERNAL COMPOSITE
INTERNAL COMPOSITE					POWER

Power

Switch

48