Multi-Tech Systems DT101 F.4 Phone Number Memory Commands, Storing Phone Numbers, D...N, N...N

DataTalker Owner’s Manual

F.4 Phone Number Memory Commands

Storing Phone Numbers D...N

A telephone number and command line of up to sixty characters may be stored in the MMH2834’s number memory. As many as ten of these numbers may be stored. Each number will be given a name, using the codes N0, N1, N2 up to N9. A phone number is stored by entering ATD, then the number as it would be dialed, along with any P, T, R, ; or comma characters, and then entering N followed by the number’s “name,” which would be any number from 0 through 9, and then hitting RETURN.

For example, the tone-dialed number 1-612-631-3550 would be stored as number N3 by entering ATDT16126313550N3 and RETURN. The number is not dialed with this store command. After storing a number, check to see that it has been stored correctly by typing ATL and hitting

RETURN.

When phone numbers are stored, the entire command line is also stored so that you can effectively create a macro for each number. For example, if you know a particular number needs to detect busy signals or dial tones, and needs extended result codes, error correction, XON/ XOFF flow control, pacing, and data compression enabled, the command line would be: ATX4&E1&E5&E13&E15DT16126313550N3. This would store the entire command at location N3.

Number Linking N...N

You may command the MMH2834 to dial another number automatically if the first number dialed is bysy. This would be useful in a situation where a computer can be accessed through more than one phone number. This is called “linking.” To link the number in N1 to the number N2, simply enter ATN1N2 and hit RETURN. Several numbers can be linked in the same command. For example, you could link N1 to N2 to N3 to N4 by entering ATN1N2N3N4 and RETURN or you could link N1 to N2 and back to N1 and then back to N2 by entering ATN1N2N1N2 and

RETURN.

The only limit on the number of numbers that can be linked is the 60 characters allowed in a command line. Number linking can not be used with blind dialing, since busy signals would not be detected. You would have to select the Wait-for-Dial tone dialing method using the X Command in order to use the Number Linking feature.

Listing Numbers Stored in Memory L

Telephone numbers that you have stored in the MMH2834's memory may be listed and displayed with the L command. It will display all ten stored N numbers in a format like that shown below. All digits and command letters will be shown. The storage location number (0–9) is shown first, followed by the complete dialing command and telephone number as originally entered.

Simply enter ATL and hit RETURN to display these numbers on your video screen or printer. An example of an L command listing is shown below:

0T14082345678

1T16125551212;

2P9,T14089876543

3T3738315,12101,16126313550

4T6313551R

5

6P9,4258513

8X4&E1&E5&E13&E15DT16126313550

9T12138880123

132