Multi-Tech Systems DT101/xx, DT102/xx owner manual DataTalker Owner’s Manual, Enter

DataTalker Owner’s Manual

Data Port Configuration
1	- Async/Sync:	Sync
2	- Speed:	19200
3	- Clocking:	Internal
4	- Idle Condition:	Flags
5	- NRZ/NRZI Encoding:	NRZ
6	- CRC Preset:	All 1s
7	- Inter-frame Timer:	Off

S - Store All Configuations

M - Main Menu

P - Previous Menu

Selection : _

Press P to return to the Data Port Configuration menu, enter S to store all configurations, and then press P again to return to the previous menu. At the Configurations menu, enter 2 and press

ENTER.

The Voice/Fax Channel 1 Configuration menu is displayed. For LAN 1, set voice/fax channel 1 for an FXO connection as the local interface type (option 6), and keep the default FXS as the remote interface type (option 11). LAN 2 must be set just the opposite (FXS for the local interface and FXO for the remote interface). For the other selections, accept the defaults .

Voice/Fax Channel 1 Configuration

1	-	Destination Channel		: 1
2	-	Digitizing Rate		: 9600
3	-	Output	Level Atten.	: 12
4	-	Input Level Gain		: 03
5	-	Silence Suppression		: Off
6	-	Local Interface Type		: FXS
7	-	Ground/Loop Start (FXS)		: Loop
8	-	2 or	4 Wire (E&M)	: N/A
9	-	Dialtone/Wink (E&M)		: N/A
10 -		Wink	Timer (E&M)	: N/A
11 -		Remote	Interface Type	: FXS
12 -		Ground/Loop Start (FXS)		: Loop
13 -		2 or	4 Wire (E&M)	: N/A
14 -		Dialtone/Wink (E&M)		: N/A

S- Store All Configurations M - Main Menu

P - Previous Menu

Selection : _

Enter S and press ENTER to store all configurations for LAN 1.

Set up LAN 2 in the same manner, but switch the local and remote interface types (FXS for the local interface and FXO for the remote interface). When you have finished selecting the LAN 2 options, enter S to store all configuration. Enter P to return to the Configurations menu.

At the Configurations menu, enter 3 and press ENTER to display the composite link configuration menu.

30