Multi-Tech Systems DT101/xx, DT102/xx owner manual Configuration

Chapter 2 - Configuration

To configure the DataTalker, enter 1 and press ENTER.

The Configurations menu is displayed. From this menu you can configure the data port, voice/fax channel(s), or the composite link. You can also select various factory defaults and store your current configuration:

Configurations

1 - Data Port Configuration

2 - Voice/Fax Channel(s) Configuration

3 - Composite Link Configuration

4 - Factory Default Configuration Options

5 - Configure Remote Unit

S - Store All Configurations

M - Main Menu

P - Previous Menu

Selection : _

For configuration 3, let’s start by configuring the data port. Enter 1 and press ENTER. The Data Port Configuration menu is displayed:

Data Port Configuration

1	-	Async/Sync:		Async
2	-	Speed:		19200
3	-	Word	Length:	8
4	-	Stop	Bits:	1
5	-	Parity:		None
6	-	Flow	Control:	CTS
7	-	Enq/Ack Flow Control:		Off
8	-	Echo:		Off
9	-	Pacing:		Off
10 - EIA Pass Through:				Off
11	-	Pass	Xon:	Off

S- Store All Configurations M - Main Menu

P - Previous Menu Selection : _

Since the data port in this configuration is going to be set up for synchronous operation, only two options apply: Clocking and Speed. Enter 1 and press ENTER to change to the synchronous mode of operation. At the Sync Data Port Configuration menu, select the appropriate speed by entering its menu list number. Use caution when setting the speed—the sync data channel could very easily overrun the composite link if the speed is set too high. Enter 2 and press ENTER to change the clocking to internal, which allows the DataTalker to provide the clock.

29