Multi-Tech Systems DT102/xx, DT101/xx Appendix F - MMH2834 Modem Commands F.1 Introduction

Appendix F - MMH2834 Modem Commands

Appendix F - MMH2834 Modem Commands

F.1 Introduction

Before you can enter commands for the MMH2834 internal composite link modem, you must access the modem using the composite link access enable command (#CLA1). When you have configured the MMH2834 modem, disable access from the command port to the composite link using the composite link access disable command (#CLA0). The following sections describe the MMH2834 modem commands.

MMH2834 Command Summary

TYPE	COMMAND	DESCRIPTION
Dial	D	Dial
(Section F.2)	A: or :	Continuous Redial
	$D	DTR Dialing
	N	Dial a Stored Number
Modify Dialing	P/T	Pulse/Tone Dialing
Procedures	&P	Set Pulse Dial Ratios
(Section F.3)	,	Automatic Pauses in dialing
	Y	Long Space Disconnect
	W	Wait for New Dial Tone
	R	Reverse Mode of Operation
	!	Flash On Hook
	$	AT&T “Calling Card” Tones
	@	Quiet Answer
Memorize Phone	D...N	Store Phone Numbers
Numbers	NN	Number Linking
(Section F.4)	L	List Numbers Stored in Memory
Store Modem	&F	Load Factory Defaults
Configurations	&W	Store Configuration & S-Register Parameters
and Defaults	Z	Reset Modem
(Section F.5)	V	Result Code Terse/Verbose
	&M	Synchronous/Asynchronous Mode Select
	&X	Synchronous Transmit Clock Select
Configure	Q	Result Codes Enable/Disable Response
Command	&Q	Result Code Selection
Responses	E	Echo Command Characters
(Section F.6)	V	Result Code Terse/Verbose
	X	Result Code...Basic/Extended/Call Progress
Condition	&T	Remote Digital Loop Signal
Phone Line	#T	Enable/Disable Trellis Coded Modulation
(Section F.7)
RS232C Interface	&D	Data Terminal Ready Control
(Section F.8)

127