Multi-Tech Systems DT101/xx, DT102/xx owner manual Unpacking and Configuration

Chapter 4 - Unpacking and Configuration

To verify and/or change the terminal adapter’s configuration, select option 2, wait 5 seconds, and enter AT!V to access the terminal adapter’s configuration menu. Refer to the ISDN Terminal Adapter Owner’s Manual for configuration commands. To exit the terminal adapter’s configuration menu, enter CTRL+X; then, to return to the DataTalker’s Composite Link Settings - Internal TA menu, press ENTER, Q.

When you have set all the options for the terminal adapter, enter S and press ENTER to store all configurations. Then enter P and press ENTER to return to the Configurations menu.

18If the composite link device is an external device, verify that the configuration options meet the conditions of your installation.

C o m p o s i t e L i n k S e t t i n g s - E x t e r n a l D e v i c e

1	-	On-Line XMT Rate:			56000
2	-	Clocking:			External
3	-	Back	to	Back:	Off
4	-	DOD/DOI:			On
5	-	DOI	Timer:		03min
6	-	DOD	Toggle DTR:		40sec
S - Store All Configurations
M	-	Main	Menu
P	-	Previous		Menu
Selection :				_

If you need to change an option, select its number from the menu.

•Set option 1, Clocking, to match the external device; i.e., if the external device supplies clocking, set option 1 to “External.”

•Set option 2, Speed, to the same rate as the external device.

When you have set all the options for the external device, enter S and press ENTER to store all configurations. Then enter M and press ENTER to return to the Main Menu. Enter 5 and press ENTER to exit command mode.

19When you have finished configuring the DataTalker, disconnect the terminal or PC from the command port and place DIP switch position 3 in the OPEN (up) position to change the data/ command port over to a data channel.

This completes the configuration of the DataTalker. Proceed to Chapter 5, “Installation,” to cable the DataTalker.

53