Appendix
10.There are two copper‐plated holes at the LED edge of the circuit card. Place a nut beneath each hole, with the lock washer side in contact with board. Attach a standoff to each location.
Standoff locations (2) at LED edge
of board (top view).
Standoff/nut attachment
(rear bottom view)
11.Locate the male 60‐pin vertical connector near the LED edge of the main circuit card. Check that pins are straight and evenly spaced. If not, then correct for straightness and spacing. Locate the 60‐pin female connector on the upgrade circuit card.
12.Set the upgrade circuit card on top of the main circuit card. Align the upgrade card’s 4 pairs of phone‐jacks with the 4 pairs of holes in the backplane of the main card. Slide the phone jacks into the holes.
13.Mate the upgrade card’s 60‐pin female connector with the main card’s 60‐pin male connector.
* *
*These screws (4 places) attach upgrade card
to main card.
* |
*
14.There are four copper‐plated attachment holes, two each at the front and rear edges of the upgrade card. Attach the upgrade card to the main card using 4 Phillips screws. Ensure the upgrade card is now be firmly attached to the main card.
15.Slide the main circuit card back into the chassis far enough to allow re‐connection of power cable.
16.Re‐connect power cable.
17.Slide the main circuit card fully into the chassis.
18.Re‐attach the backplane of the main circuit card to the chassis with 3 screws.
MultiVOIP® Voice/Fax over IP Gateways | 147 |
