
Chapter 3 – Installing Software
7.In the next wizard panel, select the COM port that the command PC uses when communicating with the MultiVOIP unit.
After you install the software, you can re‐set the COM port using the MultiVOIP Software. To do so, from the sidebar menu, select Connection Settings. Or use keyboard shortcut Ctrl + G.
Note: If the COM port setting made here conflicts with the actual COM port resources available in the command PC, the “Error in Opencomm handle” message appears when the MultiVOIP program is launched. If this occurs, you must reset the COM port.
8.The InstallShield Wizard Complete panel appears.
Click Finish.
9.After you install the software, you are prompted to run the MultiVOIP software to configure the VOIP.
Software installation is now complete.
MultiVOIP® Voice/Fax over IP Gateways | 19 |