Chapter 4 – Configuring Your MultiVOIP
Configuring FXS Loop Start Parameters
The figure and table that follow describe the parameters applicable to FXS Loop Start.
FXS Loop Start Interface: Parameter Definitions
Field Name | Values | Description |
|
|
|
Dialing Options fields |
| |
|
|
|
FXS (Loop Start) | Y/N | Enables FXS Loop Start interface type. |
|
|
|
Inter Digit Timer | 1 ‐ 10 seconds | This is the length of time that the MultiVOIP waits between digits. When the |
|
| time expires, the MultiVOIP looks in the outbound phonebook for the number |
|
| entered and place the call accordingly. |
|
| Default = 2. |
|
|
|
Message Waiting Indication | ‐‐ | Not applicable to |
|
|
|
Inter Digit Regeneration | in milliseconds | The length of time between the outputting of DTMF digits. |
Time |
| Default = 100 ms. |
|
|
|
FXS Options fields |
| |
|
|
|
FXS Ring Count, FXS | 1‐10 | Maximum number of rings that the MultiVOIP issues before giving up the |
|
| attempted call. |
|
|
|
Current Loss | Y/N | When enabled, the MultiVOIP interrupts loop current in the FXS circuit to |
|
| initiate a disconnection. This tells the device connected to the FXS port to hang |
|
| up. The Multi‐VOIP cannot drop the call; the FXS device must go on hook. |
|
|
|
Generate Current Reversal | Y/N | When selected, this option implements Answer Supervision and Disconnect |
|
| Supervision to the FXO interface using current reversal to indicate events. |
|
| Applicable only when FXS and FXO interfaces are connected back to back. |
|
|
|
Table is continued on next page… |
|
MultiVOIP® Voice/Fax over IP Gateways | 45 |