Multitech 810-FX, MVP210 Configuring Snmp, Snmp Parameter Definitions, Trap Manager Parameters

Chapter 4 – Configuring Your MultiVOIP

Configuring SNMP

If you want to manage your MultiVOIP remotely using the MultiVoipManager software, set the Simple Network Management Protocol parameters. To make the MultiVOIP controllable by a remote PC running the MultiVoipManager software, check the Enable SNMP Agent checkbox on the SNMP Parameters window.

The –SS and –FX series MultiVOIPs have limited SNMP functions available. If this is something you want to use on those models, contact Multi‐Tech support for assistance.

The table that follows describes the SNMP Parameter fields.

			SNMP Parameter Definitions
Field Name		Values		Description
Enable SNMP Agent		Y/N		Enables the SNMP code in the firmware of the MultiVOIP. This must be
				enabled for the MultiVOIP to communicate with and be controllable by the
				MultiVoipManager software.
				Default: disabled
Trap Manager Parameters
Address	n.n.n.n			IP address of MultiVoipManager PC.
Community	‐‐			A “community” is a group of VOIP endpoints that can communicate with each
Name				other. Often “public” is used to designate a grouping where all end users have
				access to entire VOIP network. However, calling permissions can be
				configured to restrict access as needed.
Port Number	162			The default port number of the SNMP manager receiving the traps is the
				standard port 162.
Community	Length = 19 characters (max.)			First community grouping.
Name 1	Case sensitive.
Permissions	Read‐Only,			If this community needs to change MultiVOIP settings, select Read/Write.
	Read/Write			Otherwise, select Read‐Only to view settings.
Community	Length = 19 characters (max.)			Second community grouping
Name 2	Case sensitive.
Permissions	Read‐Only,			If this community needs to change MultiVOIP settings, select Read/Write.
	Read/Write			Otherwise, select Read‐Only to view settings.

66 MultiVOIP® Voice/Fax over IP Gateways