National Instruments AT E Series Table4-4. I/OSignal Summary for the AT-MIO-16E-10 and AT-MIO-16DE-10 (Continued)

Chapter4 ConnectingSignals
©NationalInstruments Corporation 4-11 ATE Series User Manual
PFI4/GPCTR1_GATE DIO —Vcc+0.5 3.5 at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
GPCTR1_OUT DO — — 3.5at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
PFI5/UPDATE* DIO —Vcc+0.5 3.5 at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
PFI6/WFTRIG DIO —Vcc+0.5 3.5 at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
PFI7/STARTSCAN DIO —Vcc+0.5 3.5 at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
PFI8/GPCTR0_SOURCE DIO —Vcc+0.5 3.5 at
(Vcc-0.4)
5at0.4 1.5 50kΩpu
PFI9/GPCTR0_GATE DIO —Vcc+0.5 3.5 at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
GPCTR0_OUT DO — — 3.5at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
FREQ_OUT DO — — 3.5at
(Vcc–0.4)
5at0.4 1.5 50kΩpu
1DIO<6..7>are also pulled down with a 50 kΩresistor.
AI= Analog Input DIO= Digital Input/Output pu=pull up
AO= Analog Output DO= Digital Output
Thetolerance on the 50 kΩpull-up and pull-down resistors is very large. Actual valuemay range between17 kΩand 100 kΩ.
Table4-4. I/OSignal Summary for the AT-MIO-16E-10 and AT-MIO-16DE-10 (Continued)
SignalName Drive
Impedance
Input/
Output
Protection
(Volts)
On/Off
Source
(mAat V)
Sink
(mAat V)
Rise
Time
(ns) Bias