Chapter 3: Setup

Introduction

This chapter describes how to configure the BIOS CMOS options. Following this Introduction, there are sections specific to Pentium terminals and sections specific to Pentium III/Celeron terminals.

Note: An external alphanumeric keyboard is not required to run the BIOS CMOS Setup Utility, but a keyboard makes the setup easier.

BIOS Versions

The Setup Menus in this chapter reference NCR 7401/7454 BIOS Version 1.5.0.4 (Pentium) and NCR 7401/7452/7453/7454/7455 BIOS Version 2.1.2.x (Pentium III).

Entering Setup Without a Keyboard

1.Apply power to the terminal.

2.Calibrate the touch screen.

a)When the screen prompt that says Touch the screen two times to enter Setup appears, touch the screen three times. This causes the system to bypass the BIOS Setup and go directly to the Touch Screen Calibration Setup.

Note: Setup can also be entered from the Boot Menu that is displayed when you press ESC during POST.

b)As instructed on the screen, touch the circle near the lower-left corner of the screen. For best results, press the screen near the circle and then slide your finger onto the circle without raising your finger from the screen.

Page 89
Image 89
NCR NCR7454 manual Bios Versions, Entering Setup Without a Keyboard