4.Pull out the ejector toward you lightly.
Pulling the ejector toward you allows the FC Switch Module to be pulled out and thus the connector of the FC Switch Module to be removed from the mating connector of the Blade Enclosure (SIGMABLADE).
5.Take out the FC Switch Module from the Blade Enclosure (SIGMABLADE).
6.Install a dummy module or blank cover in the switch module slot from which the FC Switch Module was just removed.
For installing a dummy module or blank cover in a Blade Enclosure (SIGMABLADE), refer to the User’s Guide of the Blade Enclosure (SIGMABLADE).
CAUTION
Avoid installation in extreme temperature conditions.
If you need to remove the FC Switch Module due to occurrence of an error, wait until the FC Switch Module is fully cooled down after performing job in step 4.
It is because the module is heated at a high temperature.
- 50 -