Network Technologies ASI-IP-GTW, DVB-ASI to IP user manual Installing the Equipment, Introduction

ASI-IP-GTW User's Manual

2 Installing the Equipment

2.1 Introduction

2.1.1 Read this first!

The ASI-IP-GTW must be handled carefully and thoughtfully to prevent safety hazards and damage. Ensure that the personnel designated to install the unit have the appropriate skills and knowledge.

Follow the instructions for installation and only use installation accessories recommended by the manufacturer.

2.1.2 To inspect package content

oInspect the shipping container for damage. If your shipping container is damaged, keep the shipping container or cushioning material until you have inspected the contents of the shipment for completeness and have checked that the ASI-IP-GTW mechanically and electrically.

oVerify that you received the following items and any optional accessories you may have ordered:

o ASI to IP Gateway o Power cord

o User’s manual

Note: 48V DC versions do not ship with a power cord, but a male Power D-SUB connector for soldering to the supply leads.

2.2 Installing the Equipment

2.2.1 Selecting a site for the equipment

The ASI-IP-GTW should not be placed where it will be a subject to extreme temperatures, humidity, or electromagnetic interference.

Specifically, the site you select should meet the following requirements:

oThe ambient temperature should be between 0 to 50 degrees Celsius (32 and 122 degrees Fahrenheit).

oThe relative humidity should be less than 90 percent, non- condensing. Do not install the unit in areas of high humidity or where there is danger of water ingress.

oSurrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength.

oMake sure that the equipment receives adequate ventilation. Do not block the ventilation holes on each side of the ASI-IP-GTW.

oThe power outlet should be within 1.8 meters (6 feet) of the ASI-IP- GTW.

Page 15