iR1200 Modem
Message | Explanation | |
| • An invalid parameter was entered. | |
| The command line is ready for another | |
| command. Make sure that the command | |
| (and parameter) that you entered are valid. | |
|
| |
BUSY | The number you called is busy. You should | |
try the call again later. The modem is ready | ||
| ||
| to accept another command. | |
|
| |
MODEM | Your communication software assumes that | |
Auto Baud is supported by the modem. | ||
INITIALIZATION | ||
FAILED | Make sure that: | |
| • That the baud rate = 19200 bps. | |
| • If Auto Baud is turned on in the | |
| software, it must be turned on in the | |
| programming menu of your modem. | |
|
| |
NO CARRIER | Your connection was terminated, or an | |
attempt to establish the connection failed. | ||
| ||
| Try your call again and contact your iDEN | |
| carrier. | |
|
|
Diagnostic Commands
If a data connection could not be established, you might be able to determine the cause through the AT command interface.
The following steps describe how to obtain modem or system information that will help you with configuration or communication problems.
1Close all data applications. These applications may start a retry command that will interfere with your troubleshooting efforts.
2Unplug and reconnect the data cable. This will terminate
94 | nextel.com |
