Nextel comm IR1200 manual Registers, Programming the S-Register

S-Registers

S-Registers

In this chapter, you are will learn about S-registers and how to configure registers for your iR1200 modem.

This chapter includes:

S-Register	Page 87
Programming S-Register	Page 87
Reading S-Register	Page 88
Supported S-Register	Page 88

S-Registers

S-registers are memory locations in the modem that you can program to meet your communication needs. S-register parameters are numbered from 0 (zero) to 255. Since many of the registers are reserved for internal operation purposes, you are allowed to customize only a subset of the modem’s register.

Programming the S-Register

The following table describes the steps to program an S-Register.

1From the command mode of your communication software, type ATSn=x where n is the number of the S-register you wish to customize and x is the value that you wish to assign to that register.

2Press ENTER to execute the command.

You may experience undesirable consequences if you

! modify the S7 or S10 registers from their set default values. For optimal performance, it is recommended that you use the default values set for these two registers.

RFM-4002-5015 Rev 3 87