Technicolor - Thomson SpeedTouchTM620 Remote Web Interface Access, Configuration via CLI commands

Chapter 8

SpeedTouch™ Remote Access

8.1 Remote Web Interface Access

Introduction The SpeedTouch™ web interface is provided by the SpeedTouch™ HTTP web server. Access to this server and hence the web interface is controlled by the HTTP service. By default, the HTTP service is configured to let the web server accept http requests from LAN side only. In addition the SpeedTouch™ provides HTTPs access. This provides a more secure way (HTTP over ssl) of accessing the SpeedTouch™ HTTP web server.

Default HTTP Use the following CLI command to see the default HTTP service configuration. service configuration

=>:service system list name=HTTP expand=enabled			State
Idx Name	Protocol	SrcPort DstPort Group

-----------------------------------------------------------------------

1 HTTP	tcp	80	enabled
	Description	HTTP web server
	Properties	server
	Managed parameters	state port acl map log
	Interface Access List	lan local
	Ip Access List	any
	NAT Port List	80

=>

Configuration via CLI commands

For WAN access, you should use HTTP. For this, additional configuration of the HTTP service is needed.

Use the following CLI command to allow HTTP access from the WAN to the SpeedTouch™:

=>:service system ifadd name=HTTP group=wan =>

If you take a look at the HTTP service configuration, you will see that the wan group is added to the Interface Access List:

=>:service system list name=HTTP expand=enabled			State
Idx Name	Protocol	SrcPort DstPort Group

-----------------------------------------------------------------------

1 HTTP	tcp	80	enabled
	Description	HTTP web server
	Properties	server
	Managed parameters	state port acl map log
	Interface Access List	lan local wan
	Ip Access List	any
	NAT Port List	80

=>

E-DOC-CTC-20051017-0155 v1.0 81