Technicolor - Thomson SpeedTouchTM620 manual 138

Chapter 10

SpeedTouch™ Monitoring

ADSL and SHDSL MIBs Following two MIBs are specific per SpeedTouch™’s DSL variant (ADSL or SHDSL variants). You should only load the appropriate MIB, although loading both will not harm functionality. To retrieve maximum SNMP information it is imperative to use the MIB provided on the SpeedTouch™ Setup CD, and not the one supported (if so) by the SNMP manager.

RFC2662 ADSL MIB (containing ADSL-LINE-MIB and ADSL-TC-MIB)

The ADSL MIB is in fact a bundle of three MIBs: the ADSL-LINE-MIB, the ADSL TC- MIB and additionally the PerfHist-TC-MIB. It contains management information about the ADSL line such as Signal-to-Noise Ratio (SNR), output power and attainable bit rate. For using the RFC2662 ADSL MIB, the PerfHist- TC-MIB is required, available on the SpeedTouch™ Setup CD.

RFC3276 SHDSL MIB

The SHDSL MIB contains management information about the SHDSL line such as Signal-to-Noise Ratio (SNR), Loop attenuation, PSD regional setting, line rate and line status.

ILMI MIBs The SpeedTouch™ supports the following ILMI MIBs:

af-ilmi-065.000

fb-nm-0122

fb-nm-0165

ATM MIBs Following MIBs are specific for the SpeedTouch™ ATM interfaces:

RFC2515 ATM MIB

This is the MIB Module for ATM and AAL5-related objects for managing ATM interfaces, ATM virtual links, ATM cross-connects, AAL5 entities, and AAL5 connections.

RFC2514 ATM-TC-MIB

This MIB Module provides Textual Conventions and OBJECT-IDENTITY

Objects to be used by ATM systems.

138 E-DOC-CTC-20051017-0155 v1.0