Technicolor - Thomson SpeedTouchTM620 manual =service system modify name=SSH state=enabled port=35

Chapter 8

SpeedTouch™ Remote Access

Hyper-NAT Refinements The SpeedTouch™ features a powerful Hyper-NAT engine allowing the local hosts to share a single (remotely negotiated) public IP address.

In case Hyper-NAT is enabled on the WAN interface that will be used for remote management, and a static mapping has been made to allow remote hosts to address regular SSH services on a host residing on your local network, you must make sure that accessing the SpeedTouch™ Web Interface is still possible.

For more information on Hyper-NAT, see the SpeedTouch™ Hyper-NAT

Configuration Guide.

The default port for the SSH server is set to 22. This can be changed by executing the following command:

=>:service system modify name=SSH state=enabled port=35

The command above will change the SSH server port of the SpeedTouch™ from port 22 (default) to port 35.

=>:service system list name=SSH expand=enabled
Idx Name		Protocol	SrcPort DstPort Group
----------------------------------------------------------------------
	1 SSH	tcp	35
	Description		SSH server
	Properties		server
	Attributes		state port aclip aclif aclifgroup map log
	User Managed Attributes....		state aclip aclif aclifgroup map log
	Attribute Values :
	State		enabled
	Port		35
	Ip Access List		any
	Interface Access List		any
	Interface Group Access List lan
	Map List		35
	Logging		disabled
	NAT-refinements for SpeedTouch™ services should never be made in the
!	NAT configuration menu, but always in System Services.

96 E-DOC-CTC-20051017-0155 v1.0